The right way to Build a Shelf Utilizing Brackets

Brackets are available in a myriad of shapes and sizes. Utilizing brackets to help and create a shelf permits the shelf to be coordinated with the room decor, be custom-sized, and be constructed by an intermediately skilled dwelling decor DIY-er. A number of shelves, staggered on a wall, make a critical design statement. A shelf placed above a door is a found-space storage answer, and a collection of cabinets running round a room’s perimeter, high on a wall, could make a lateral book case for a small library.

Step 1

Choose brackets that may accommodate the chosen shelf. A typical shelf is 12 inches deep. This is the measurement from the entrance of the shelf to the wall. Brackets are basically “L” -shaped; one leg of the L is hooked up to the wall, the opposite leg, which protrudes from the wall at a ninety-degree angle, supports the shelf. The length of the protruding leg must be at least two-thirds of the depth of the shelf. For example, if the desired shelf is 12 inches deep, the supporting legs of the bracket must be at the least 8 inches. Often, each legs of the brackets are the same length; but this is not a hard rule.

Step 2

Choose the number of brackets to use for the shelf. If the brackets are spaced too far aside, the shelf will sag. A superb rule of thumb is to position a bracket every sixteen inches. Place one at each end of the shelf, 1 inch from the outside edge, and every sixteen inches along the shelf length.

Step three

Mark the wall, with the self-erasing marker, on the place of the belowside of the shelf. Measure the space from the floor to this mark. The ninety-degree angle of the bracket might be aligned with this mark. The shelf will sit on the legs of the brackets that protrude from the wall at this mark. Mark the wall, measuring up from the ground, at 16-inch increments, one location marker for every bracket and one mark for each of the end brackets.

Step 4

Set up the brackets onto the wall on the indicated bracket locations, following the manufacturer’s directions for attaching the brackets to the wall.

Step 5

Place the shelf, centered, on prime of the brackets and insert screws up through the brackets into the bottom of the shelf to secure it into position. It is useful to pre-drill the screw holes to prevent a wood shelf from splitting.

If you are you looking for more on Heavy Duty Shelf Brackets take a look at our web site.

© 2022 Middlebury Energy . Powered by WordPress. Theme by Viva Themes.